Maintaining Swiss-Type Lathe Fixtures – Locking Accuracy at the Micron Level

Daily “Clean + Lubricate” as the Baseline
After each shift, remove chips and coolant residue from the fixture surface and collet jaws with a soft cloth or air gun to prevent corrosion and re-clamping errors. Every eight hours, apply a trace of rust preventive oil to spring collets, guide bushings and other moving parts; once a week, add a thin coat of grease to ball-screw nuts and hydraulic cylinder rods to reduce wear. Before any prolonged shutdown, spray anti-rust oil on internal bores and locating faces and wrap them in wax paper or plastic film.

Precision Calibration & Data Closure
Use ring gauges or master bars every month to verify repeatability of the fixture; log results in the MES. If deviation exceeds 0.005 mm, trigger compensation or repair. For quick-change systems (HSK/Capto), check taper contact percentage every six months—target ≥ 80 %. If lower, re-grind or replace.

Spare Parts & Training
Keep minimum stock of jaws, seals and springs to enable replacement within two hours. Hold quarterly on-machine training sessions for operators on correct clamping practices and anomaly recognition to eliminate abusive clamping.

In short, embedding “clean–lubricate–inspect–calibrate” into daily SOP keeps the fixture delivering micron-level accuracy, reduces downtime, and extends overall machine life.