Key Points for Adjusting Guide Rail Clearance on CNC Machines Tools

Preparation Before Adjustment

1. Ensure the Machine is Stationary and Power is Off:
   • Before adjusting the guide rail clearance, make sure the machine is in a stationary state and the power supply is disconnected.
2. Clean the Guide Rail Surface:
   • Inspect and clean the guide rail surface to remove any oil, dust, or other impurities. This ensures that the adjustment is not affected by foreign materials.
3. Check the Flatness of the Guide Rail:
   • Ensure that the guide rail surface is flat and free from any bending or deformation. If any issues are detected, they should be addressed promptly.

Adjustment Methods and Points to Note

1. Check Parallelism of the Guide Rail:
   • Use measuring tools to take measurements at four points (top, bottom, left, and right) along the guide rail. Record the height values and calculate the height differences to determine if the guide rail is parallel.
   • If the guide rail is not parallel, adjust the installation position of the guide rail or use shims to correct it.
2. Adjust the Guide Rail Clearance:
   • Insertion Strip Adjustment: Insert an insertion strip to adjust the side clearance of rectangular or dovetail guide rails. Adjust the position of the strip by moving the adjusting screws to achieve the desired clearance. Flat insertion strips are easier to adjust but have lower rigidity, making them suitable for general applications. Wedge-shaped insertion strips offer higher rigidity but are more difficult to manufacture.
   • Press Plate Adjustment: Adjust the clearance by repositioning the press plate or changing the thickness of the shims between the press plate and the mating surface. This method is more convenient than scraping the press plate but may reduce the contact rigidity of the mating surfaces.
   • Adjusting the Preload of the Guide Rail Slides: Use professional tools to measure the clearance on both sides of the guide rail. Adjust the screws or nuts on the slides to change the preload, ensuring that the slides are in tight contact with the guide rail.
3. Operational Points During Adjustment:
   • Follow the principle of “coarse adjustment first, then fine adjustment” to gradually reach the desired state.
   • Avoid excessive force during adjustment to prevent deformation of the guide rail, which could affect precision.
   • Ensure that the machine bed is level during the adjustment process to maintain the accuracy of the guide rail clearance.
4. Post-Adjustment Inspection and Testing:
   • After completing the adjustment, remeasure the guide rail clearance to ensure it meets the expected results.
   • Conduct a trial run to observe the operation of the guide rail. Ensure that the guide rail runs smoothly without any abnormal vibrations or noises.

Subsequent Maintenance

1. Regular Inspection and Maintenance:
   • Regularly inspect the guide rail clearance and address any issues promptly to ensure the long-term stable operation of the machine.
2. Maintain Good Lubrication:
   • Ensure that the guide rail lubrication system is working properly. Regularly replace the lubricating oil to reduce wear on the components.
3. Control the Working Environment:
   • Maintain a stable temperature in the machine's working environment to avoid expansion or contraction of the guide rail due to temperature fluctuations, which could affect clearance accuracy.